Xianxian Yongsheng Environmental Protection Equipment Co., Ltd.

&< Welcome< Xianxian Yongsheng Environmental Protection Equipment Co., Ltd.< Our company is an entity processing and manufacturing enterprise. Dust collector equipment has been sold to all provinces and cities across the country. The company relies on a perfect after-sales system to survive and develop with integrity. Product quality is reliable< Dust collector < The steel plates and shapes used in manufacturing are all national standards and the thickness reaches the standard. The whole process is made and welded firmly. In the early stage, we can provide measurement services to design the dust removal equipment more accurately for you. In the later stage, if there are quality problems with the equipment, our company can also send technicians to repair it (the entire process is not required) If you need to understand and design For bag dust collectors that are corrosive to oil, acid and alkali Preventive measures:
Pour fuel into the boiler plant when the boiler is started and when the fan is running at full load, because the combustion of fuel will produce oily gas. At this time, the gas drawn by the fan will be oily, which will damage the bag and block it. We need to take preventive measures on the boiler side. When all the dust collector equipment on the boiler side is started, the inside of the boiler is mainly heated by the combustion of fuel, so the content of oil and water will be very high. Also, the temperature of the gas pipeline will be very low at the beginning of the dust removal. Condensation may occur in the filter bag inside the dust collector. When the load is reduced when the boiler dust collector is running, the amount of fuel burned is very small. It only plays a role in supporting combustion. In this way, the oil content in the flue gas will be much smaller. The whole dust collector, If the temperature of the air volume pipe is high, it is very good for the dust collector bag. The high temperature bag should be -℃. The method to prevent oily gas from entering the bag dust collector is now mainly to pre-discharge the powder boiler fly ash, which needs to be put into no less than / First put in hours and check the situation. When the boiler is at full load and the oil is discharged to support combustion, whether the powder spraying equipment is added and started depends on the combustion situation of the fuel under the working conditions on site. If the combustion is relatively transparent, the powder spraying system does not need to be turned on.